Put a LAMA on your handlebars with the TerraCycle LAMA Clamp Mount and Mirror Kit! The LAMA Clamp is perfect for bars on both uprights and ‘bents, fairing mounts, even seat backs and rails for tandem stokers who want to see what’s behind them.
Bought it for my Bacchetta CA 3.0 recumbent bike. This is the only mirror I have ever used on a recumbent that stays where it is set. The other mirrors and mounts stay put until you ride. Or lean your bike up against something. Or walk close to the mirror. Or touch the mirror. I actually had to loosen the mounting clamps a bit so I could adjust it when needed. But I haven't needed to adjust the mirror. If you tighten down the clamps, it seems like I could pick up my bike with just the mirror. (I'm not actually suggesting you pick up your bike using just the mirror, but I've thought about it.). It's actually a bit tough to pop the LAMA pieces apart and together. I removed the elbow piece since I didn't need for my situation and popped the remaining pieces together. Rock steady mirror mount.
I was looking for mirrors that could be mounted forward and low, as seen in the pic. my prior ones were off the handlebars ends and I had to turn my head further than I liked as it took my eyes off the front.
I also needed some that could be turned inward easier and yet would not move one riding had started.
So far so good. Easy to mount and good articulation..
ALong with my other goodies you cant go wrong with T-cycle goodies...
Was looking for mirrors that would not move and could be mounted more forward so less head turn when riding.
The articulate more than expected and that helped in being able to mount in a great place and are very firm..
A++ indeed and another great T-Cycle product..
Probably tried 6-8 different mirrors over the last few years. These are the only ones that stay adjusted and don't vibrate loose!!!!! Highly recommend them.
Wildly over priced. There are equally excellent mirrors for bar mounting at a fraction of the cost. They use a Mirrcycle mirror head which is excellent . The clamp screws are low quality zinc plated screws. I am replacing them with stainless. I bought it on sale on a whim as my German designed wonderful Wittkop mirror’s stalk is a little thin and vibrates bad enough that I can barely use it on rough roads. When I could use Mirrcycle’s bar-end mirror they were rock solid. I am hopping this short stiff arm will be like that. I have yet to install it. It may not work on the bike I bought it for as the arm has less reach than the Wittkop.
What I love and appreciate about these LAMA Clamp Mount and Mirror Kits are once they are installed and you have them adjusted, you can forget about having to readjust them because of the clever and ingenious engineering that went into designing these TO STAY PUT WHERE YOU PUT THEM!!!!!!
Kind regards
Paul
The two gimbal joints make it possible to reach nearly any configuration you need in order to clear both your gloved hand, your cycling computer, and your wheel (recumbent trike).
