The Greenspeed Dual Idler Kit is here to eliminate those lengthy chaintubes. A T-Cycle Power and Return idler are paired using a Clamp-On Single-Sided Chain Keeper to allow the idlers to float side by side as you change gears and conquer mighty terrains. Since the chains do pass so close to the bike by the steering linkage and cruciform tube, you might need a small chaintube there to prevent contact (we recommend a pair of Floating Chaintube Holders, but only because they're super high quality and easy to install).
Note: On pre-2008 trikes, the idler shaft is 10mm. On 2008 and later trikes, the idler shaft is 8mm. Elite level idlers for 10mm shafts come with ABEC rated 10mm steel bearings. Elite level idlers for 8mm shafts come with 8mm hybrid ceramic bearings.
Greenspeed Idler Kit
Very good service and excellent quality product. It came from the US to Australia much quicker than I expected. Very pleased, thank you
Excellent product, just didn't work well on my greenspeed GT 20. Not T-Cycles fault
Excellent packaging and well put together product for my ICE VTX. Noticeably less friction in the drive chain after fitting. Would highly recommend
Replacement for original toothed idler
Replaced the original tubes and idler on Greenspeed GTO. Much better solution than factory. I found that I needed to route the return chain on the top side. So now I need a dual sided chain keeper -- on order. Outstanding quality as usual from T-Cycle.