These are 8mm ID aluminum spacers, custom cut on a C&C lathe specifically for T-Cycle idlers. Kit Includes:
- 2x 0.09in spacers
- 2x 0.30in spacers
- 1x 0.60in spacers
You can use a 0.09in spacer between a Power idler and a flat surface, like a chain keeper or an idler mount. The 0.09in spacer can also be used between the power side of an Over/Under idler and a flat surface. The 0.30in spacer is for spacing a Return idler away from a flat surface. The 0.30in spacer can also separate a Return idler and a Power idler. Finally, the 0.60in spacer is used between the return side of an Over/Under idler and a flat surface.
Not exactly what I needed but it worked.
I ordered this spacer kit after inquiring about replacing the lost spacer on my TERRACYCLE idler on my HP Velotechnik Scorpion. After receiving the kit and not finding the size required and spending a considerable amount of time checking the size with calipers I contacted the company and was told that the kit didn’t include the size required for the Scorpion idler but I could make it work using two of the spacers that were included. Problem solved but I should have been told that when I first inquired about replacing the missing spacer; would have saved time and emails back and forth.
They worked great. i had to position my elite multi-purpose idler"upside down" on my Azub to get the chain to clear the suspension for crown and the idlers also needed to be on the lowest bolt hole which allowed the idler to contact the idler clamp. switching out the spacers corrected the position and it runs great.
Well made, typical T-Cycle gear. Solved my problem nicely
Necessary little pieces
Very useful not being required to cut individual lengths
Just what I needed
Finding the right spacers for the idler setup on my older bent was so much easier with the T-Cycle Spacer kit. Definitely improved the idler/chain management system on my bent. Good quality and good service. Will use T-Cycle again.